I needed an Alldocube tablet holder including a case - I hope I didn't inadvertently copy someone's design. Two versions with or without support.

Tested on Alldocube iPlay30, iPlay40 and iPlay50 including cover.

Basic version V01-1: 23.26m of filament
Basic version with single support V01-2: 25,80m of filament
Basic version with two supports V01-3: 26,92m of filament
Edit version V02-1: 23,38m of filament
Edit version with single support V02-2: 25,26m of filament
Edit version with two supports V02-3: 26,37m of filament

Angle holder: 75°
Material: any (tested PLA, PETG)

Print settings:
Nozzle: 0.4
Layer height: 0.2
Perimeters: 3
Top layers: 5
Bottom layers: 4
Padding: 15% grid
Supports: NO