Meant to hold and store tea, vertical . The slot at the bottom allows it to function as a dispenser. I can't get the text on the lid to show after printing, and I can't figure that out. I am working on a V2 that uses a mechanism with a rubber band so scaling isn't needed. If you got any ideas for improvements, I will love to hear them.

Happy Printing

PS- sorry for the bad photo… next time I’ll do better.

Print Settings

Printer Brand:

Creality

Printer: 

Ender-3 v2

Rafts:

Doesn't Matter

Supports: 

Recommended, If supports are used use Trees or an easy to remove pattern.

Resolution:

.2

Infill: 

20%

Filament: Generic PLA Any color you want(I did black)

Notes:

I would recommend scaling by 101%-102%, due to the fact the teabags fit too snugly and won't drop down via gravity.

Post-Printing =============

The Lid

The lid should be Printed upside down. This box is not a square(and neither is the lid), so if it doesn't fit the first time, try rotating it until it does. Remember to scale the lid to the same scale of the box.

Category: Household