Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
You can put up to 60 pairs of earrings. The total print takes about a small dozen hours. Assembly manual:
- Print the main trunk
- if you have printed both parts, assemble them together. You can use glue but it is not essential.
- Take the small clips and insert the branches into them.
- Take the branches and just created clips and fit them into the trunk (The bottom branch moves a bit more, it's so you can remove it without dropping all your earrings)
102
Curtidas
162
Downloads
1
Impressões
Categoria
Bathroom
Tags
holder
tree
earing
Licença
Creative Commons — Attribution — Share Alike
Arquivos (5)
lower part trunk.stl
101.3 KB
branches.stl
108 KB
trunk 1 part.stl
215.9 KB
higher part trunk.stl
240.8 KB
clips.stl
129 KB