Bic pen offset holder

Angled offset pen holder for a Bic pen. Just add a pen tip. You can also attach the original body onto the backside (not shown in picture).

This holder has a 53 degree angle from the table which fits my specific holding angle and makes the pen tip upright so it doesn't scratch while writing. The tip is aligned to be in the centerline of the grip so there's no strange feedback when writing. It should feel just like a regular pen in the hands.

This is up to Version 4 with the elongated back and hexagonal grip.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

Supports:

Yes

Resolution:

.4mm nozzle x .15mm layer

Infill:

1.5mm walls, 30% infill

Filament: any PLA+ any

Notes:

Use a brim and an overhang of 50 degrees. Draw one custom support up to the center of the pen. Print in the same orientation as you would hold the pen so the cylinder that holds the pen needs no internal support.

Category: Office

Descrição

Print Settings