This has been my most complex build to date. I made a fully 3d printed enclosure for a mini arcade, bartop arcade, desk arcade. It is based on a rapsberry pi 4 and the retropie software. It uses an LCD touchscreen (1024x600). Below is the build video that covers the BOM and assembly proccess. 

Video: 

• LCD Display [https://amzn.to/3FsGbd9](https://amzn.to/3FsGbd9) 
• Raspberry pi 4 kit [https://amzn.to/3EoYXkq](https://amzn.to/3EoYXkq)
• Button kit (new easier to connect version) [https://amzn.to/3EE16Zu](https://amzn.to/3EE16Zu) 
• Button kit like mine [https://amzn.to/3pCJt8g](https://amzn.to/3pCJt8g) 
• Audio amplifier kit [https://amzn.to/3eiH2RO](https://amzn.to/3eiH2RO) 
• Input bulkhead connector [https://amzn.to/3eiQjcz](https://amzn.to/3eiQjcz)
• Power cable [https://amzn.to/3qmAMht](https://amzn.to/3qmAMht) 
• Power brick [https://amzn.to/3H3FpDK](https://amzn.to/3H3FpDK) 
• 1/4" wooden panels 2ft x 2ft Home Depot 
• M2 M3 M4 Screws, bolts, kit [https://amzn.to/3stAmZt](https://amzn.to/3stAmZt) 
• volume knob [https://amzn.to/30TX6q0](https://amzn.to/30TX6q0) 
• HDMI alternate cable [https://amzn.to/33Oj3rz](https://amzn.to/33Oj3rz) 
• HDMI 180 degree Adapter [https://amzn.to/3Jqeqoa](https://amzn.to/3Jqeqoa) 
• HDMI F to Female Adapter [https://amzn.to/32n4ECC](https://amzn.to/32n4ECC) 
• Female USB Breakout board [https://amzn.to/3pqkTaK](https://amzn.to/3pqkTaK) 
• 180 degree USB adapter [https://amzn.to/31d0nB4](https://amzn.to/31d0nB4) 
• USB f to female adepter [https://amzn.to/3eCamTE](https://amzn.to/3eCamTE) 
• Jumper wire kit [https://amzn.to/3EoCDYi](https://amzn.to/3EoCDYi) 
• Weller solder station [https://amzn.to/3pkITMd](https://amzn.to/3pkITMd)

Sliced using Cura with stock/standard settings and no supports also no  bed adhesion.