The door of one of the Midwest dog crates in my car wouldn't stay open anymore and swing close when I was trying to load my old dog.

So I came up with this simple doorstop. It goes on one of the horizontal wires in the door and simply flips over the top wire of the crate's front panel to hold the door in place.

I designed it for Midwest crates but I suspect it will work with just about any brand.

Print instructions

Supports: Yes

Resolution: 0.3mm

Infill: 20%

Notes:

Use ABS or PETG. PLA will melt in the heat of a car.

Supports are required but come off easily.

If you like what I'm doing…

 … consider buying me a coffee or joining my Club.