This is a mini version of my FPV-Rover V2.0

The dimension are 10cm x 10cm x 3cm

Intructions and BOM can be found on Instructables
[https://www.instructables.com/id/Mini-FPV-Rover/](https://www.instructables.com/id/Mini-FPV-Rover/)

Videos on Youtube:
 

Print instructions

Body: Print body with about 20%-25% infill and use supportmaterial

Track: Print it with 0.1mm layer height, so that you receive a smooth finish. No support needed

Cog: Print with about 25% infill and use supportmaterial

Rubbertrack: Use Ninjaflex or TPU for the rubbertracks.

Inner track frame: Print with about 25% infill. No support needed

Outer track frame: Print with about 25% infill. No support needed

Top: Print with about 20%-25% infill and use supportmaterial

Pins: Use 1,75mm filament as pins for the track

Parts to print
1x body
70x track
70x rubbertrack (only if needed)
1x top
2x inner track frame
2x outer track frame
4x cog