This device keeps the BL Touch pin from dropping when the magnet fails from overheating.

It just slips on to the body and keeps the pin from dropping. It is easily tilted out of the way when actually using the BL Touch.

Use a heat tolerant filament.

It looks like it would be easier to print laying down, but then the layer orientation would result in the arms breaking. As orientated requires supports. I set the support for angles greater than 55 degrees and support density to 25%.

It will cause the Probe to blink (error) while printing, but this is not a problem. Leveling with the probe requires a printer restart to clear the error.