Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
Vented enclosure for 3cm x 7cm PCB prototype board. I'm using boards from (this kit.
Just slide the board into the grooves, stick any wires into the slot, and screw the cover on with #6 screws. Wood screws were near my desk while I was designing this, but I'm sure machine screws would be fine too.
The countersunk holes on the cover need some support while printing
9
Me gusta
56
Descargas
Categoría
Electronics
Etiquetas
case
electronics
pcb
thingiverse
electronicsenclosure
prototype
Licencia
Creative Commons — Attribution — Noncommercial — Share Alike
Archivos (2)
case.stl
213.2 KB
cover.stl
250.7 KB
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta