I recreated some classic (JDM-)wheels. 

They're approximately 1:3 scale and have an diameter of around 13.5cm and a width of around 9cm. 

They're not a perfect copy as I drew them just after some pictures from the internet. 

Print them as you like, but I suggest to use "Archimedean chords" as the infill for the top layer, especially on wheels with silver faces. 

The inner and outer lip should be printed with the flange down and print quite good without supports.

You'll also need: 

M1.6x8mm bolts and nuts 

or  M1.6x6mm bolts and no nuts, should be fine without nuts, depending on the tolerances. 

Maybe some glue for the center cap or if the centers are multi-piece

Highly recommend tools for putting them together: T handle by Kezat + 3mm Socket by me

For more lip options please check my other designs: 

Slant Lips

Narrower Lips

Zero Lips

I'll do more designs soon, and I'm open for wheel suggestions.