This is a remix of an Adafruit project, and requires electronic components from Adafruit to complete. Assembly instructions at thingiverse.com (in the next week).

Print instructions

Front and Back- printed at 0.2mm Layer Height with a 0.4mm nozzle, no supports

Side Number - printed at 0.10mm Layer Height with a 0.25mm nozzle, no supports

Keys - printed at 0.2mm Layer Height with a 0.4mm nozzle. You will need to print 7 and you will need to print with Proto-Pasta Conductive Filament

Case - printed at 0.2mm Layer Height. Supports are needed, but are not needed everywhere (only on the sides and the middle where the keypad sits