Yeah, I know, angled scrapper is cool but it needs supports to print. 

I know, but… Its much more easy to use than the regular scrappers. 

Why you ask?

Well, a couple of reasons:

1. Is more ergonomic, fits better in the hand and you can even press the scrapper with one finger while holding it, making it easier to get underneath those pesky prints;
2. When you finally are a bit under the print you can pivot the scrapper and make model pop from the bed with little effort (definition of effort might vary from person to person ;) )

So yeah…, I know supports, but I think its worth having then and then get a better concept ;)

Also if you find it to be a bit small, you can scale it up a bit.

Printing Instructions:

I suggest you using PTEG or similiar.

Material: PETG (or similar)

Infill: 15%

Supports: Yes

Change filament during print: Only if you want

Brim: Not needed

Raft: No

All models are print ready oriented.