Part 2 of my amazingly interesting and satisfying “3D print your gutter” series (refer to my gutter drain screen for part 1)… the wife wanted a rain barrel, so I cut the gutter.  Unfortunately, that meant there was no support for the gutter, so I had to make something to keep it from blowing around.

Standard 2x3 gutter, run two tap-cons in and you're done (assuming you have masonry block).

Made from PETG to handle the outdoors.

Part 3 is coming… I want to make something to flip back and forth between the rain barrel and the gutter, and then when the rain barrel over flows it goes right to the gutter.  Goal for this winter.