3D printable hooks for pride flags that look rather... hmm... Fully parametric -- if the angle or the size are too large for your holes, it's as easy as editing the numbers in Fusion360, then right-clicking the relevant ready body and clicking "Save as Mesh". These fit most ring-based pride flags. The included STL's are pre-emptively sized for GRK 114069 screws that I abuse everywhere.

Please note, these are not, and should never be, load bearing. Layer separation is ALWAYS the weakest point of an FDM print, and the layers aredirectly on the shear line with this design. Hanging is fine, but don't pull on it or anything.

Print with 200 shells top/bottom. Yes I'm serious, makeevery layer a shell, with 2 perimeters. slicers might get weird with 100% infill, but they seem to doreally well with making every single layer a shell. Is it necessary? Maybe not, idk, it certainly doesn't hurt though.

Rare CC-BY-SA, but mostly because I kinda want to see what people do with it. For remixes (remember, those*must* also be CC-BY-SA), please do give credit to me.

Category: Decor