Prevents cats from messing about with the soil in plant pots. My naugthy cat was always spreading dirt around and using the pot as a loo! :) Not anymore!!

Plants can still be watered if printed without the bottom/top layers.

This model is designed for a 25-27cm pot, I can share the tinkercad file to allow larger or smaller pot sizes (you you can resize it when slicing, just remember to divide the pot diameter by half)

either use the gcode (already sliced) or, when slicing the STL, play with the following settings to find a design that you like

use Height range modifier with this settings:
Settings for height range:
Start at height: 0 mm
Stop at height: 1 mm
Layer range Settings to modify:
Layers and Perimeters:
Bottom: 0
Perimeters: 3
Top: 0
Then change Infill in Print Settings:
Fill density: 30%
Fill pattern: Honeycomb