I wanted something that I could use to clip my cables together and was reusable. This was inspired by the Dino Clip. When the latch is closed it holds together with a good amount of force. It could be used to hang things off a backpack, hold key loops together, or whatever else you can think of. This is a print in place object. I did use a little bit of support where the lever connects to the top. If your bridging is good, you shouldn't need it. After it's done printing push the ring jaws together until it breaks loose. Then press the lever toward the ring jaws until it breaks free.

After I was done designing it I noticed I inadvertently made it to look like a M67 grenade. So print it in olive drab and use it to hang your real grenades. (please don't do that!!!!)

Print Settings

Printer:

Hypercube Evolution (HEVO)

Rafts:

Supports:

Doesn't Matter

Resolution:

Infill:

25%

Filament:

whatever

Category: Tools