Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Small AFG for Keymod rail, Odinworks inspired. Small but comfortable for a good hand angle if using a thumb over bore grip.
I could only get it on with just the rear pin in place with the keymod screws i had which seemed short. It is still on there very solid.
Print laying on its side with support only for 80 degree overhangs. I used PETG and .2 layer at 55mm per sec, 30% infill in Cura.
Print Settings
Printer:
Anet A6
Rafts:
No
Supports:
Yes
Resolution:
.2
Infill:
30
Notes:
Print laying on its side, locating pins should be a press fit, I didnt use the forward pin and its solid.
Category: Sport & Outdoors
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta