Check out the new version:
[https://www.prusaprinters.org/prints/55640-prusa-sorting-tower-mk2](https://www.prusaprinters.org/prints/55640-prusa-sorting-tower-mk2)

don't know what to do with your old prusa spools?
make a sorting tower so you can organize all your small parts.
works for all prusa spools!!

you can also check out my vase mode version on my page.

Print instructions

this sorting tower, can be made as high as you dare, and there is 3 different draw sizes.
everytime you have a new empty spools, two new layers can be added to the tower.

the base set seen in orange in the disassembled picture is the all that is needed to get started.

top and base is the foundation parts.
then for each layer a connector a draw guide and 4 drawers are needed in the same size, either low, medium or high.

once the base parts are printed, disassemble a PRUSA spool and take the two sides from it, these will be the building blocks of the tower.

if you don't know what to do with the center piece of the spool check out "PRUSA Spool PiggyBank" or "PRUSA Spool Container - Screw Lid" on my page!

happy printing!!!