Chip Clip remix

Added some recesses for 2mm magnets (2 for the small, 4 for the med and large) to srwilson58's original clip. These work great for chips, candy, or just about anything else. Adding the magnets allows mine to be stored on my fridge for easy access.

Original designer [https://www.thingiverse.com/thing:1212828](https://www.thingiverse.com/thing:1212828)

I used these magnets from Apex [https://www.apexmagnets.com/magnets/2mm-x-2mm-cylinders-neodymium-magnet](https://www.apexmagnets.com/magnets/2mm-x-2mm-cylinders-neodymium-magnet)

Print Settings

Printer Brand:

Creality

Printer:

CR-10

Rafts:

Supports:

Resolution:

200

Infill:

Filament: MatterHackers PLA Lt Blue Post-Printing =============

Used a heat gun to "open" the recess a little and gently set the magnets in with a non-ferrous tool (I used a bamboo skewer [very handy when dealing with magnets]). Lastly, I covered the magnets with instant glue to seal them in (just as an extra precaution).

Category: Household Supplies

Descrição

Print Settings