This is a case I made for my loops ear plugs as when searching it turned out no one's made them yet.
I fidget a lot so the original case that came with them lasted only a couple of hours before I snapped it in half.

Ear plugs from here [https://au.loopearplugs.com/](https://au.loopearplugs.com/)

This case does have my (hobby) logo on its lid but feel free to wipe that off, its mainly for my own self 

Best results for me have been to print both outer sides onto the build plate as then you don't need support structure.

Clean up needs a 2mm hole drilled for the pivot.

The magnet clasp use 12x3mm magnets I happened to have on hand from another project with a dot of super glue for reassurance (the hole is a pretty firm fit).

Initially I only planned to use a piece of filament super glued in for the hinge to test with but I haven't managed to break it yet so i guess that's permanent now.

In the photo I used a creality ender 6 to print with ebay pla.