Updated September 14th, 2025

One of the first three designs for my series of playmat tubes for table top card games.

The files in the download are solid and must be printed used vase mode in order to work properly. In the download section you will find the following files. These follow the same naming convention of my other playmat tube designs and the parts are interchangeable.

• Playmat_Tube_Spiral_Base
• Playmat_Tube_Spiral_Center
• Playmat_Tube_Spiral_Top
• Playmat_Tube_Cap
• Playmat_Tube_Spiral_Top_V2
• Playmat_Tube_Spiral_Top_Short        (this version is 3cm shorter)

There are two versions of this design that can me printed a screw top version with a cap and a snap top version.

• For the snap top version print two Bases and one Top_V2 this version is 38.0cm long.
• For the screw top version print one Base, one Center, one Top, and one Cap to create a tube 38.5cm (15 inches) long. Many people have fond it hard to get thicker playmats into and out of this version.

Both will hold a standard side playmat 60 by 35cm (23.5 by 14 inches) but you can make either version longer by adding Centers sections. Each extra section one will extend the tube by 12.5cm (4.9 inches).

My other playmat tube designs are:

• Spots
• Stripes
• Spin
• Swish
• Hex

Note:

This model was designed to be printed using a .4mm diameter nozzle. Using any other size will prevent the parts from fitting together.