This model includes a few ways of printing: 

1. Two halves that need to be printed and glued onto each other
2. the blade and hilt seperate from each other
3. the blade and hilt seperate from each other BUT the hilt is split in two halves
4. As a full piece

The front/back are not the same model, one has the triforce on it so if you don't want that, then don't use that side.

There's also a pedestal included, though you would have to cut off the blade at some point if you want to permanently leave it in there. If there's enough requests I can maybe figure out a way to do that non-destructively (maybe like one of those lightsabers)

Also Check out the shield model: [https://www.printables.com/model/288911-hylian-shield-tloz](https://www.printables.com/model/288911-hylian-shield-tloz)

I'd include the ZTL but it's unsupported so ¯\_(ツ)_/¯