If you're like me, you made the DIY Prusa enclosure with the IKEA LACK tables (link here)

However, I found that the LACK tables are too short and I can't easily troubleshoot my printer without sitting on the ground, and I don't want the added instability of stacking another LACK table underneath. 

BOOM - introducing these LACK risers. Print 4 of these bad boys and they will raise your table up to a standard bedside table height (~21 inches). Each one takes 1x #10 (3/16) wood screw and I'd recommend a pan head since there's no countersink in the model.  Use pilot holes! The link to the ones I used is here, or just get them at home depot. Theoretically, the screw is optional. 

The image shows the Prusa printer on a standard bedside table, and the LACK table with the risers in front of it, comes out to the same height. 

Enjoy! 

Edit: included a .3mf that prints all 4 (PLA) and g-codes for both!