Raspberry Pi Zero W case for OctoPi

This is a case for a Raspberry Pi Zero W with Camera. The camera module is a cheap chinese clone with the long flatcable.

I tried to use as few metal screws as possible. Everything is printable except the USB connector and the screws for the USB-connector holder. The female type A USB connector I used is from an old computer housing, those type of connectors are also sold on Aliexpress.

Because i made the part for the USB connector separate, it is very easy to make your own for whichever type of connector you want.

The two base parts snap together, no screws needed.

Print Settings

Printer:

CTC i3

Rafts:

Supports:

Yes

Resolution:

0.2

Infill:

20%

Notes:

Only the Camera latch needs supports

Post-Printing =============

I designed the holes for the camera latch to small. I did not want to print it again, so i used a dremel tool to make the pins on the latch a bit thinner.

Category: 3D Printer Accessories

Descrição

Print Settings