Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Ever have problems with your shower curtain fluttering such that water runs down it and out of the shower stall? Well, here's a simple little block to tape at the edge of a shower so that the shower curtain doesn't escape the shower stall. A small piece of VHB (very high bond strength) tape is used to fix each block in place.
Print Settings
Printer Brand:
MakerGear
Printer:
MakerGear M2
Rafts:
No
Supports:
No
Resolution:
0.25mm
Infill:
5%
Filament: Any Brand PLA Any Color
Notes:
A trivial print with the part laying on the side that will face the inside of the shower. The ones shown were printed using silver silk PLA to blend-in with other shower fittings, but are still visible enough so that one doesn't trip on them going in/out of the shower.
Category: Bathroom
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta