Raspberry Pi Camera Stand

Because this camera has a large focal distance and fixing the device in the printer frame does not provide the best image. This stand allows other uses to the camera.

Features

• Compatible with the official Pi Camera rev 1.3 and similar designs
• 7 options for camera lens center height - from 5cm to 20cm
• No hinge in the base - for people who believe and respect the law of gravity
• Use a 3mm x 20mm bolt or a nail as hinge
• The case is slighly raised to protect the lens without compromising the view angle
• This will not deform with time even if installed in the horizontal

Print instructions

• Use supports only to the bed, when printing the pole and the box.
• Remember that the indicated height is from the bottom to the camera lens, not the pole height.