Tiled Wolverine Claws

=================

I have remixed them from "Wolverine Claws in plastic" by user "chefmaki". I really liked this claws and my cousin wanted to have a pair of them for a costume party, but unfortunately they don't fit on most delta-printers because they are too large. No problem, tiled claws to the rescue!

I suggest printing them from ABS

...so you can glue the "dovetail"-part later with acetone.

Also uploaded the scad-file and the original STLs from chefmaki, because they are needed for modification on the scad file.

Instructions

Made from silver/grey ABS (ABS is suggested here because you can glue then together with acetone).

You might have to cut the dovetail-section down a bit, because the tiles of the claws have been seperated in software without a gap!

for one complete "Claw" you need

• 1x handle bar
• 3x bottom claw part
• 3x top claw part

Category: Accessories