This is a raspberry pi stand. Its inspired from the adafruit stand for the pi zero ([https://learn.adafruit.com/raspberry-pi-zero-stand/](https://learn.adafruit.com/raspberry-pi-zero-stand/)) but with a few fundamental changes

The hight where the pi is screwed in is quite high up. Mainly because when you put a hat on the pi zero stand it tended to tip over with the weight. This I hope should be better in this design.

The screw holes are hat compatible so you can put a A+ or a pimoroni black hat hacker on it or just a Hat on its own. Of course you could put a regular pi on this stand but the USB would be sticking out to the side. (Not a big deal for me)

The hole for the cable management is a little higher than the Zero version too because stiff cables tended to make the whole stand lift off the table. This time I hope the placement allows for cable bend.