Hi all, This is origanaly uploaded for a competition for 3D printer hosted on My Mini Factory. [https://www.myminifactory.com/pages/bbcmicrobit](https://www.myminifactory.com/pages/bbcmicrobit) The Case.stl can be printed without support and must be done on its back- with the walls up The Plate.stl will need support material but only due to the battery holder piece. The battery pack slot is the origanal one that comes with the microbit. Any recomendations and fixes please let me know :)

MICROBIT IPHONE CASE DESIGN: (iPhone 6)

Parts: x2

• Plate.stl
• Case.stl

• In Cura needed to be at 10x scale!

• The Case.stl can be printed without support

• The Plate.stl will need to be printed with support material on due to the battery pack holder design

• The Plate.stl piece will be put into the Case.stl piece once printed and then the phone goes in the case.

• Then the microbit can be put on the back and so too can the battery pack that comes with the microbit, they then can be connected with the normal power cable

Print Settings

Printer:

Wanhao i3 & 6

Supports: 

Yes

Resolution:

0.2 or 0.1

Infill: 

50

Notes:

Only the plate.stl file requires supports!

Category: Hobby