What is this?

These are stackable boxes to store your filament with little to no assembly.

How to use this?

1. Choose models with or without connectors (without it requires it to be printed separately).
2. Choose between a half holder and a full holder.
3. Resize to fit your needs (To fit your filament spool, if you want extra support on connectors or not).
   1. (Picture 3) To use the extra support (only for separately printed connectors), make the holders fit into the little rings inside to connectors (if you don't understand, just don't do this step).
4. Print your holders, connectors (optional), a connector piece for the top (as a lid), and the tube corresponding with how many containers you are going to stack.
5. Stack your containers, insert your filament, and put the tube in the hole at the top.
6. Enjoy!

Recommended Print Settings:

1. 0.4mm-0.8mm nozzle
2. 0.20-0.30 layer height
3. No supports should be fine, but if you want to be sure, you can add them around the connectors.