I made this so that two characters can take up the same space (one is a flying character). After testing a couple prints I found that the fully attached ones worked the best. Unless you are good at adhering parts together I would suggest those ones. Please follow the print instructions for the best results.

The picture shows two characters on it (which would increase its stability) however it was tested without the weight at the bottom and held up just fine. Anything short of really smacking the side of the table proved futile.

Print Settings

Printer:

Creator Pro

Rafts:

Supports:

Yes

Infill:

Notes:

My best results came from the fully connected ones. I laid them on their side (so the printer was printing long ways) threw in some supports, Increased the infill to 80% (100% would work better) and it turned out great. I used PLA btw.

Category: Toy & Game Accessories