Snail trap for the garden. Fill it with approx. 300ml of beer and two table spoons of sugar.

Staut beer works very good!

Heavily influenced by this great design: [https://www.thingiverse.com/thing:3635146](https://www.thingiverse.com/thing:3635146)

But it was to big for my PRUSA look a like, so I made my own design.

You have to separate the parts in the slicer, CURA can do it, so I suspect PRUSA slicer also can.

Glue the lid and lifting knob together and glue the three legs on, they have small pegs for alignment. I used thick super glue.

Remember enough bottom layers, so the bottom and sides are water tight! Would be a shame to loose all the beer without catching any snails.

I printed mine using Bondtech CHT nozzle at 0,3mm layerheight and 0,605mm line width and arachne engine. 

Prints without support.

Printed in PLA.