Author : TinkrMakr

I changed the angle to 45° because I read in the comments that some people had problems to properly print the lower part of the model. I had the same problem, but I don’t think it came from the angle of the model but from the fact that I was printing the PETG with too low a temperature. I have an MK3S with the MMU2S, and when I print Prusament PETG in single material the nozzle temperature is set to 250° whereas when I use multi material with the same material the nozzle temperature is set to 230°? And that’s why I had printing quality problems on the lower part of the model. I realized by printing the temperature tower, below 235° the quality is not there. I will soon relaunch a print of the model with the original 35° angle using the correct print temperature

Thank to TinkrMakr for his work and sharing.

Added 45° angle knurled version