In the same style as my Discipline 65 case, here is a case for the LCK75, R2. I'm saying R2, because I'm not sure if this would fit an R1 board or not. If the bottom plate is unchanged from R1 to R2, this will fit an R1 as well.

Print it in whatever you want. The one pictured is in sparkle PLA. My previous ones have been in ABS. When plating, be sure to set it down on the bottom surface. Prints without supports. With a 0.6 nozzle at 120mm/s it's roughly 5 hours a side to print.

The LCK75 project can be found here: [https://github.com/lyso1/LCK75r2](https://github.com/lyso1/LCK75r2)