micro:bit croc clip keeper

Works with a micro:bit v1 or v2. Note that the edge comesvery close to some small components 10 mm from the edge of the board, but shouldn't touch or interfere unless your printer's Z-scale is incorrect. As ever, take care fitting anything to a circuit board …

tiny guard piece to stop croc clips / alligator clips shorting out on your micro:bit. Designed entirely from the Kitronik mechanical drawings, as the official ones are useless.

Print Settings

Printer Brand:

Prusa

Printer:

I3 MK3S

Rafts:

Supports:

Resolution:

0.2 mm

Infill:

15%

Filament: Filaments.ca Canadian Maker Series Low Sheen Tough PLA Black

Notes:

No supports, but you might want to enable bridging.

Model already has elephant's foot compensation built in.

Category: Electronics

Descrição

Print Settings