Replacement bed feet/risers for bedframes with 22mm I.D., 28mm O.D. steel pipe legs.

Print instructions

Suggest printing with polycarbonate
Suggest printing no more than two or three at a time
As always, use an enclosure for polycarbonate
The hole filler must be printed in the opposite layer orientation (flat on the bed) and inserted into the hole in the foot. This provides maximum strength of the material to prevent the bed leg from snapping off at the top due to delamination of the print layers.
Hole Fillers:
Brim
4 Perimeters
20% gyroid infill
Feet:
8 Layers Top
4 Layers Bottom
20% gyroid infill