This is a small cabinet I created for my niece. The design should have a clean look and should provide lots of space for the tiny pieces of her toys. I've printed four boxes because of ... space.

As usual I've attached the Fusion 360 file to make adjustments easier for you.

Side note: I'm new to 3D printing and I've to learn everything. I believe that making things on your own from the very first step is harder but finally you will get things done. Because of that I try not to download lot of things but create them from scratch. Even if they already exists. By sharing those things I hope to get feedback that I can improve my skills. So don't be angry if I upload things which already exists here.

Unless I can't upload Fusion 360 files here, you have to download those from my thingiverse page: [https://www.thingiverse.com/thing:2798219](https://www.thingiverse.com/thing:2798219)

Print instructions

Resolution: 02.mm or better
Infill: doesn't matter 10% - 20%
Support, Rafts: No

You want to glue the the top and the bottom part together. I printed this in PLA and a tiny amount of superglue just worked fine for me.

All tolerances worked out fine for me so sanding was not necessary. Depending on your printer (calibration) this might vary on your side.