A light diffuser and button protector for Nitecore TIP SE flashlight.

A minimalist, lightweight flashlight “lantern” for ambient light in the tent or hammock.

The diffuser has two positions.
Collapsed/pushed all the way in = button protector, so the light doesn't turn on by mistake.
Extended = Light diffuser.
There are tabs on the print that fit into the notches in the side of the flashlight.

I used a generic transparent PLA. (Clas Ohlson, here in Sweden)
But any transparent filament will most likely work well.

Wall-thickness is 1.4 mm.
Thin enough to allow light through. Thick enough to protect the buttons.

Version 5 has a more loose fit. Version 6 is a bit tighter (perfect on the flashlight I've got).