Xbox Headset Ikea Lack Table Hook

A hook for hooking things, although it's main purpose for me is for my Xbox One headset.

I have a Turtle Beach Recon 40x headset and this was measured for that although I'm pretty sure it'll fit the standard headset.

One design is branded with the Turtle Beach logo, one with the Xbox logo and the one plain.

It was also measured to fit on the edge of a lack table. I added screw holes but super glue or strong double sided tape will probably be enough.

Update:

Looks like 4 screw holes was a bit overkill. I've only used the top two and it's on there solid. 15% infill is also probably too much, it's quite stiff and is only holding up a 250gram headset lol.

Update 2:

Edited all of them to have 2 screw holes instead of the 4, much cleaner.

Print Settings

Printer:

Tevo Tarantula

Rafts:

Supports:

Resolution:

0.2

Infill:

15%

Notes:

Use a large brim, I've already had 2 failed prints where it pulled it off the bed and started spewing out a spaghetti mess.

Category: Video Games

Descrição

Print Settings