Wife requested a hook, wife did not state the exact nature of the hook, Sexy Tentacle Hook was born. 

This is a remix of the Magnetic tentacle hook but reworked in Meshmixer so it prints with minimal support. 

I sliced using Cura with the model at 45 degrees on the build plate. This was to help with areas where bridging was needed. I used supports touching build plate only, then added support blockers so that the only part actually getting support was the arch under the tentacle. 

I was going for maximum tentacle sexiness and didn't need the hook to carry much weight so printed at .12mm layer height, 3 walls and lightning infill (Ender 3 with .4mm noozle).

Credit for the origional design goes to Bidumadio

[https://www.thingiverse.com/thing:4822459](https://www.thingiverse.com/thing:4822459)

and John U

[https://www.printables.com/model/87246-magnetic-tentacle-hook](https://www.printables.com/model/87246-magnetic-tentacle-hook)