Você está no 3DFinder
Buscamos em Thingiverse, MakerWorld e Printables ao mesmo tempo para te dar o melhor de cada uma.
Descrição
Introduction
I've remixed my Ultimate Mini Spinning Top so you can use up the rest of the steel balls from the 8x22x7 ball bearing. Ideally you have a 4 mm or a 5 mm steel ball for this design. If you don't have a bearing at hands there is also a version which does not require a steel ball.
Print Settings
- 0.1 - 0.15 mm layer height (0.1 mm recommended)
- 3-4 perimeters
- >20 % infill (heavier tops typically spin longer)
- make sure “Thin walls” is checked
You'll get the best looking results if you print the parts sequentially
Assembly Instructions
The top and bottom part should fit snugly in the ring (you may also use some glue). If the fit is too loose or to tight, just scale the ring by 0.5-1 % accordingly.
Give it a good spin!
Happy Printing
Gostou deste modelo? Crie uma conta grátis para salvar seus favoritos e voltar a eles depois.
Criar conta