EDIT/WARNING: This must be printed in flexible filament such as TPU. It will not fit with PLA, PETG, etc. 

Google Pixel 4a (not 5g) case , based on the design by fiunkel. Changed the following:

• Removed the headphone jack (I never use it, just keep it from collecting dust this way)
• Made the side buttons outdented instead of holes. Much easier to find/press this way in my opinion
• Added a hole on the top of the phone for the top mic
• Enclosed the bottom where the usb port is and left 3 holes for the port and speakers
• Cut out the back, leaving most of it uncovered to glue a popsocket or similar (or just enjoy the phone design underneath)
• Changed the back design to hex instead of the previous pattern

Print Settings

Printer:

Sunlu S8

Rafts: 

No

Supports:

Doesn't Matter

Resolution: 

0.16

Infill:

Doesn't matter

Filament:

Unsure TPU

Blue

Notes:

I used tree supports in Cura just to make the usb port and speakers a little easier. You could get away with not using them depending on how good/bad the bridging is on your printer.

Category: Mobile Phone