This is the spaceship 'Starbug' from the British TV comedy series 'Red Dwarf'.

Instructions

Print the main body, use full support.

Print two front legs and two back legs, use full support.

Glue legs to main body. I used a drop of acetone inside the sockets. Make sure the legs are perpendicular to the body, and that the feet are parallel to the ground. I glued them and eye-balled it, then adjusted them while the acetone was still tacky.

Print two fins. Glue them as shown in the pictures.

Print the rocket part and glue to the back of the body.

That's it.

UPDATE 3/9/2012 - As requested I have created a single model file. I have not been able to test it, so please post your results if you print it. Thanks.

Category: Vehicles