Slim Hex Screwdriver

This screw driver is designed to be low profile allowing you to use a hex screw bit closer to side walls or hard to reach locations.

This works great for installing my Lack Enclosure Drawers where inserting screws near the table legs are most difficult.

HARDWARE:
• ¼" Hex bits (For installing lack enclosure drawers I recommend these long hex bits HERE)

PRINT INSTRUCTIONS
This print uses minimal material to achieve its function. 20% infill should be a great infill value but for more durability you can always increase this value as needed.

PRINT SETTINGS:
Filament: PETG
Nozzle Size: 0.4mm
Print Height: 0.2-0.35mm
Infill: 20-100%

Descrição

Slim Hex Screwdriver

Slim Hex Screwdriver