Don't you hate the way most coasters don't catch the condensation coming off your ice-cold drink? Well, this coaster is just what you need! A beautiful coaster that will protect your coffee-table or desk while you watch Battlestar Galactica.
"All of this has happened before, and it will all happen again."

Print instructions

Note: The print-time shown here is double the actual time since you only need to print one of the gCode files.

Filament changes are embedded in the gCode, so you don't have to worry about catching it, it'll wait on you and then warm-up again after you switch the filament.
Start with Black filament, then switch to Gold after about 30 minutes. Then, two and a half hours later, switch back to Black and let it finish.
I've uploaded gCode for both the 0.4mm nozzle and the 0.25mm nozzle. The 0.25mm nozzle code works for 0.3mm nozzles as well, you won't need to change anything.
Both versions come out beautiful, but the 0.25mm version has slightly sharper lettering.

Inspired by this coaster... [https://www.thingiverse.com/thing:3270192](https://www.thingiverse.com/thing:3270192)
But I liked the multi-level design of this wall decoration... [https://www.thingiverse.com/thing:1532766](https://www.thingiverse.com/thing:1532766)
So, I used the wall decoration as my starting point and created a high-wall ring around the outside.