Please reference original creators and myself if sharing/remixing.

Credit to Alex Rodriguez for the original design of this system : Modular Hydroponic System

Credit to Marc Giovannoni for the : Hydroponic 13mm Diffuser

Credit to Andy Kutruff for the : Hydroton base

My system uses the following component :

Ikea FÖRENLIG 24 cm : [https://www.ikea.com/fr/fr/p/foerenlig-cache-pot-interieur-exterieur-blanc-40454819/#content](https://www.ikea.com/fr/fr/p/foerenlig-cache-pot-interieur-exterieur-blanc-40454819/#content)

ARTDER pump : [https://www.amazon.de/gp/product/B097N7Z8K2?psc=1](https://www.amazon.de/gp/product/B097N7Z8K2?psc=1)

12/16 mm hose : [https://www.amazon.de/gp/product/B075P5FSKG?psc=1](https://www.amazon.de/gp/product/B075P5FSKG?psc=1)

2 inch cup : [https://www.amazon.de/gp/product/B07PZ7RYJB?psc=1](https://www.amazon.de/gp/product/B07PZ7RYJB?psc=1)

Hose is meant to be routed throught the center of the tower.

Almost everything can be printed with no or minimal infill (I do recommand 10-20%) and thick layer size (I have a mix of 0.2 and 0.28 mm for most). Check list below for exception.

You will need to print :

• 1* vaselid_v4.stl (print 100% filling)
• 1* Hydroton_bottom.stl (optional, meant to increase humidity by filling it with expended clay pebbles)
• X* Module.stl (as man as your pump/hose cand handle)
• 1* DripReservoir.stl
• 1* Inlet.stl (needs at least 0.2mm layer thickness, if possible go lower for the threads)
• 1* Diffuser_no_ring.stl (same as abow)
• 1* ModuleLid.stl

Check smysnk profile for an alternative.

Happy gardening !