Estás en 3DFinder
Buscamos en Thingiverse, MakerWorld y Printables al mismo tiempo para darte lo mejor de cada una.
Descripción
This two piece print uses a screw to adjust height anywhere from a 90mm to 55mm gap between the GPU shroud and the case.
Update: A few printers have expressed that the threads are tight. Be aware, depending on your print settings, you may want to add an extra off set to either piece for a better fit.
Printables
GPU Simple Sag Support Bracket
Publicado el 7 de jul. de 2024
99
Me gusta
1,502
Descargas
13
Impresiones
Categoría
Electronics
Etiquetas
support
bracket
gpu
sag
Licencia
Creative Commons — Attribution — Noncommercial — Share Alike
Archivos (2)
Bottom.stl
5.4 MB
Top.stl
9 MB
¿Te gusta este modelo? Crea una cuenta gratis para guardar tus favoritos y volver a ellos más tarde.
Crear cuenta