This is a remix for the original quad remote holder design by benanseen: [https://www.thingiverse.com/thing:4826000](https://www.thingiverse.com/thing:4826000)

in order to reduce the holder from four remotes to only two. My remix produced an imperfect .stl model but it slices well (Cura 4.8). It print well and also works well. It holds my Samsung and Roku remotes great.

My Vizio remote is a little too wide (see pic) and may be a little too thick also (it is very close) so if you wanted to fit a larger remote control, I would advise you to scale this up in the X and Y direction by a little in the slicer or just use the following triple remote holder I made to fit the Vizio remote also: [https://www.thingiverse.com/thing:4826368](https://www.thingiverse.com/thing:4826368)

Print Settings

Printer Brand:

Creality

Printer:

Rafts:

No

Supports:

Resolution:

.28

Infill:

Filament: eSun PLA+ PLA purple

Category: Electronics