This is a very simple but effective ipad stand. So many ipad stands have a very high angle for watching movies, looking at recipes , playing games, etc. but this one is made for designers to use due to the low angle it allows the ipad to sit at. it is designed to fit with and without ipad case.
It’s about and 8 hours print for two of the supports @ 15% infill.
Print out 2 supports, cut 1//4” aluminum , steel, or wood rods( found at most hardware stores) to the width you would like, and simpler glue in place. creating a very strong , stable ipad stand. and very lightweight.
also if you like this ,please feel to tip. that way I can keep designing and sharing new products to print in the thingiverse community