My wife needed a way to keep one of our dogs off of a section of wooden decking. We had a small scrap decorative garden gate, but no hinges, so this was a quick model to hang the gate.  Also included is a small manual latch for closing the gate.

This is way to thick for what was needed, but I didn't have time for revisions so my 10 minute design is what I went with. No real recommendations on print settings, but I printed with 30% infill in PETG since it was going to be outside. The screws used were 1 ¼" deck screws, so the holes are sized accordingly. Oh, and the latch should probably be flipped when printed (I'm lazy).